RandR Group
FROG RADIO CONTROL SUB SET
Frog automation sets include radio controls and safety photocells for a double leaf gate. The FROG uses two standard underground motors suitable for heavy duty residential gates.
- 2 off 230V motors
- ZA4 control panel
- 2 off mini pinks
- 433MHz receiver
- Safety photobeam
- Adjustable torque
- Adjustable interleaf delay
- Switchable auto re-close
- Self locking motors
- Manual release levers
ATi RADIO CONTROL RAM ARM SET
Ati automation sets include radio controls and safety photocells for a double leaf gate. The ATi uses two A3000 motors suitable for heavy duty residential gates set on steel posts.
- 2 off A3000 motors
- ZA4 control panel
- 2 off mini pinks
- 433MHz receiver
- Safety photobeam
- Adjustable torque
- Adjustable interleaf delay
- Switchable auto re-close
- Self locking motors
- Manual release levers
Bx RADIO CONTROL SLIDER SET
Slider automation sets include radio controls and safety photocells for a single leaf gate. The Bx uses a BxA motor with ZBx6 panel suitable for residential gates.
- Bx motors
- ZBx6 control panel
- 2 off mini pinks
- 433MHz receiver
- Safety photobeam
- Adjustable torque
- Open & close microswitches
- Switchable auto re-close
- Self locking motors
- Manual release clutch
U4281b RADIO CONTROL GARAGE DOOR SET
U4281b automation set is suitable for horizontal tracked up and over doors, and sectional doors. An adaptor can be fitted for vertically tracked doors. Designed for easy fitting, this set can be running in 1 hour. The transmission guide needs only to be bolted to the motor. A few more fixings and it is in position. V600 motor provides 500N pulling power, sufficient for most double garage doors.
- V600 garage door motor
- V0679 transmission guide
- ZL55 control panel
- TOP432na transmitter
- AF43 receiver
- TOPA433 antenna
The work involved must be undertaken in the correct stages with the necessary interim gap to allow for the natural hardening-off period of the concrete. In this period the in-factory fabrication work can take place. As a general rule, the sooner the first stage can take place the better.
The work can normally be completed within two days at stage one, then a gap of about ten days and further 3 days at stages two and three. R&R Group concentrate on carrying out our work swiftly and efficiently with a minimum of fuss, mess or bother. This ensures the end result will go on to give many, many years of satisfactory use. Special arrangements can be made for urgent pre-holiday installations, overnight or bank holiday working.